(oscilloscope, open collector output resistance in the absence of the output voltage is not) to wave at AB phase output plus
two pull ups;
three 3mm screw hole into 120 degree distribution or six 3MM screw holes into 60 degree distribution, to the center
input mode should switch to 0V function), note: if the encoder is not connected to the device to direct oscillographic
Usually we will declare the minimum value to avoid customs tax. But due to different policies in different countries, there might be customs tax that should be paid by buyer. So you could leave a message when placing the order about how much value you would like to declare.
Note: AB output must not be directly connected to the VCC, otherwise, it will burn the output transistor.
Output: AB output rectangular two-phase orthogonal pulse circuit, NPN output open collector output type, the output type
Size: encoder body size: 39 x 6 x 13mm 35.5mm; shaft; the shaft outer stop platform: high 5mm, Phi 20mm; fixed empty:
Wiring output: A phase, B phase, Vcc positive power supply, V0, shielded wire. Connection color product nameplate are
Performance: 100/200/300/360/400/600 pulses per revolution can be selected. DC5-24V power supply. Chip support
distance of 14mm;
and with internal pull-up resistor on the MCU or PLC directly connected, such as MITSUBISHI PLC (51 MCU or PLC
leather cutting machine, steel cutting fixed length controller, civilian measured height and body scale, University game