The gray level: 256
Dual signal wires version, signal can jump to transfer
BO: Backup control data signal output
WS2813 VS WS2812B(include other led strip):
8) If the transmission distance between any two points is less than 3m, another circuit is not needed.
9) When the refresh rate is 30fps, cascade numbers are far more than 1024 points.
Led Qty: 60pcs per meter
7) Dual-signal wires version, signal break-point continuous transmission.
Wave length (NM): R,650nm ; G,520nm ; B,460nm
3) Using the built-in signal reshaping circuit to achieve the signal waveform shaping, and no distortion of waveform of signal takes place.
2) The control circuit and the LED share the only power source.
6) Serial cascade interface. Data receiving and decoding depend on just one signal line.
1) The control circuit and RGB chip are integrated in a 5050 components, to form an external control pixel.
FPCB board color: Black/White
1x 5m 60 pixels/M WS2813 led strip (Power supply and controller are not included)
10) Data transmitting speed is up to 800Kbps.
DI: Control data signal input
5V: Power Voltage, connect to “+5V”